• Ben Avison's avatar
    Initial import of SDCMOS module · b8788829
    Ben Avison authored
    Detail:
      This module intercepts ByteV so every time a CMOS bte is written, it
      saves the CMOS to the file "CMOS" on whichever card was in drive SDFS::0
      when the module initialised (which will normally be the boot card, since
      the module would not normally be reinitialised after ROM initialisation).
      If you don't want to be nagged to change cards every time the CMOS is
      written, you have two options:
      * Delete the CMOS file from your boot SD card, and update your boot
        script so it doesn't try to load it
      * Use *Unplug SDCMOS
      In either case, you will then require an EEPROM carrier board if you want
      your settings to persist across a reset.
    Admin:
      Tested on beagleboard and beagleboard-xM, both with and without a CMOS
      file on the boot card.
    b8788829
Makefile 109 Bytes