Fix debugging via UART0

HAL_QueryPlatform was attempting debug output before the debug
UART had been initialised. Since both the PL011 & MiniUART
configuration depends on getting/setting firmware values, fix it
by just removing the debug prints from HAL_QueryPlatform.

VersionNum

@@ -4,18 +4,18 @@
  *
  */
 #define Module_MajorVersion_CMHG        0.82
-#define Module_MinorVersion_CMHG        Pi4.9
+#define Module_MinorVersion_CMHG        Pi4.10
 #define Module_Date_CMHG                18 Feb 2020
 
 #define Module_MajorVersion             "0.82"
 #define Module_Version                  82
-#define Module_MinorVersion             "Pi4.9"
+#define Module_MinorVersion             "Pi4.10"
 #define Module_Date                     "18 Feb 2020"
 
 #define Module_ApplicationDate          "18-Feb-20"
 
 #define Module_ComponentName            "HAL_BCM2835"
 
-#define Module_FullVersion              "0.82 (Pi4.9)"
-#define Module_HelpVersion              "0.82 (18 Feb 2020) Pi4.9"
+#define Module_FullVersion              "0.82 (Pi4.10)"
+#define Module_HelpVersion              "0.82 (18 Feb 2020) Pi4.10"
 #define Module_LibraryVersionInfo       "0:82"

s/Messaging

@@ -101,11 +101,6 @@ HAL_SendHostMessage  ROUT
 ;
 HAL_QueryPlatform    ROUT
         STMFD   R13!, {r0-r6, lr}
- [ HALDebug
-        BL      HAL_DebugTXStrInline
-        DCB     "QueryPlatform",10,0
-        ALIGN
- ]
         CPUDetect r4
         MOVCC   r4, #GPU_L2CnonAl              ; Pi 1 has L2 cache enabled
         MOVCS   r4, #GPU_UnCached              ; Pi 2 has L2 cache disabled
@@ -229,11 +224,6 @@ gbit                                   ;
         MOVNE   a1, #-1
         STR     a1, SafetyCatch
 10
- [ HALDebug
-        BL      HAL_DebugTXStrInline
-        DCB     "QueryPlatform done",10,0
-        ALIGN
- ]
         LDMFD   R13!, {r0-r6, pc}
 
 ; In: