GitLab

Detail:
  * Supports DMA controllers with no interrupts (ie those that need a bounce
    buffer).
  * Restructured interface to HAL to separate the concepts of a DMA controller
    device and a DMA channel device.
  * Bugfixes to handling of single-buffered channels.
  * Updated Doc.HAL_DMAAPI.
Admin:
  Tested with Kevin's ADFS.

Version 0.15, 4.4.2.3. Tagged as 'DMA-0_15-4_4_2_3'

Detail:
  Finally, all IOMD dependencies have been expunged, and the module will
  build again. Any specific support for new features of other DMA controllers
  has yet to be added, though. New exported header added, for use by DMA
  device code.
Admin:
  Untested. However, should theoretically work if someone were to write the
  appropriate routines for the IOMD HAL.

Version 0.15, 4.4.2.2. Tagged as 'DMA-0_15-4_4_2_2'

Detail:
  This didn't get far beyond the design stage, but what there is is best kept
  safe in CVS in case it gets accidentally deleted again...
Admin:
  Don't even think about trying to build this version.

Version 0.15, 4.4.2.1. Tagged as 'DMA-0_15-4_4_2_1'

Detail:
  Also
  * added Ursula service call table (not even the Phoebe version had one!)
  * fixed a bug: the Service_PagesUnsafe handler was returning with IRQs
    still disabled
Admin:
  Not tested.

Version 0.15. Tagged as 'DMA-0_15'

  Updated to build using objasm instead of aasm.
  Sources changed to be objasm-compatible.
Admin:
  Requires Library 0.71 or later.
  Requires BuildSys 3.06 or later.
  Requires Env 0.65 or later.

Version 0.14. Tagged as 'DMA-0_14'

Detail:
	A change in Version 0.52 of HdrSrc meant that this component would
not build. This has now been fixed.
	Makefile now uses strdepend in the clean phase to remove all the
dynamic dependencies.
	Placed under srccommit control.

Admin:
	Built.

Version 0.13. Tagged as 'DMA-0_13'